Washer & Dryer Repair in Costa Mesa, CA

Washer & Dryer Repair in Costa Mesa

We repair washers and dryers across Costa Mesa — 92626, 92627, and everything from the Eastside to South Coast Metro. We're based here, so we're usually at your door the same day you call.

Costa Mesa is our home base. Most calls in 92626 and 92627 get a same-day slot, and we carry the common dryer and washer parts on the truck.

$65 diagnostic, waived when you approve the repair. 90 days on parts and labor. Open seven days, 7 am to 9 pm.

What We Fix in Costa Mesa

Dryer not heating, washer not draining, a machine that walks across the floor on spin — those three are most of what we see. We diagnose on site, quote before we touch anything, and carry the common failure parts for Samsung, LG, Whirlpool, Maytag, GE, and Kenmore.

About 75 to 80 percent of jobs are done the same day. If a control board or motor has to be ordered, it's usually one to three business days.

We work on gas and electric dryers, top load and front load washers, stackables, and all-in-one combo units. If your set is stacked in a closet, tell us when you book so we can plan the time. Stacked and closet-installed sets are quoted after inspection — pulling and restacking adds time to the job.

Dryer Repair in Costa Mesa

Most no-heat calls come down to a thermal fuse, a heating element, or a high-limit thermostat on electric, or an igniter, flame sensor, or valve coils on gas. Noise is usually drum rollers, the idler pulley, or the rear bearing. A dryer that runs but leaves clothes damp is almost always the vent, not the dryer — we check the vent before we sell anyone a part.

Washer Repair in Costa Mesa

Won't drain is usually the coin trap, not the pump, and we clear it and run a full cycle before recommending anything. Leaks at the front point to the door boot; leaks at the back point to hoses or the tub seal. A washer that shakes hard or throws a balance code is normally worn suspension rods or shocks, and rods go in as a set of four.

Commercial Laundry Service in Costa Mesa

We service laundromats, apartment and HOA laundry rooms, hotels, and salons. Huebsch, Dexter, UniMac, Speed Queen, and Continental Girbau. Coin and card systems, heating, drives, and drain faults. Ask about a maintenance schedule if downtime costs you money — most operators we work with would rather book a quarterly visit than lose a weekend.

Housing and Water in Costa Mesa

Costa Mesa is mostly older, and the laundry setups show it. The Eastside and College Park are full of 1950s-60s tract homes with laundry in the garage and a short vent straight out the wall, which is the good scenario. Mesa Verde has more interior laundry rooms with long vent runs through the attic, and that's where we see lint-packed ducts and blown thermal fuses. The condos and newer builds off Harbor and around South Coast Metro are almost all stackables and closet units, where the machine has to come out of the closet before anything can be diagnosed.

Mesa Water District runs on local groundwater, and it's hard. Scale collects on washer inlet valve screens until the machine takes forever to fill, and customers usually blame the valve when a screen cleaning fixes it. The same scale coats heating elements and drops the coil on electric dryers early. If a washer in this city is filling slow, the screens are the first thing we pull.

Neighborhoods we cover: Eastside Costa Mesa, Mesa Verde, College Park, South Coast Metro.

Common Jobs in Costa Mesa

• Samsung dryer rumbling or squealing — worn drum rollers and idler pulley. We carry the roller kit and belt, so it's a one-visit repair.
• LG front load washer throwing UB or UE and walking across the floor — suspension rods worn out. Replaced as a set of four, never one at a time.
• Whirlpool or Maytag dryer running but not heating — thermal fuse blown because the vent is packed. Replacing the fuse without clearing the duct just blows the next one, so we clear the run too.
• Stackable units in the Harbor and Metro condos — pulling the set out of the closet to reach the belt, rollers, or drain pump. Most shops won't take these calls.
• Washer filling slow or not at all on the Eastside — scale built up on the inlet valve screens from the hard water here.

Common Problems in Costa Mesa

Dryer repair in Costa Mesa → · Washer repair in Costa Mesa →

• Dryer Not Heating
• Dryer Not Spinning
• Dryer Making Loud Noise
• Dryer Won't Start
• Dryer Takes Too Long to Dry
• Washer Not Draining
• Washer Leaking
• Washer Won't Spin
• Washer Won't Start
• Washer Shaking or UE/UB Error

Brands We Repair

Samsung

Samsung dryers fail in a pattern: worn drum rollers and idler pulley for the rumble, and the heating circuit for no heat — element, both thermal fuses, the high-limit thermostat, and the thermistor tend to go together, which is why we carry them as a set. On the washers we see drain pumps, door boots, and bearing noise. Bring us the error code if the display shows one; it narrows the diagnosis before we arrive.

LG

On LG washers, lowercase uE means the machine is still trying to rebalance itself and uppercase UE means it gave up — worth waiting out the lowercase before calling. Persistent balance codes are worn suspension rods, replaced as a set. On the dryers, d80, d90, and d95 are Flow Sense reporting duct restriction, and on gas models d80 can also mean weak gas supply rather than a clogged vent.

Whirlpool

The 27-inch Whirlpool dryer platform is the most common machine in older Costa Mesa laundry rooms. Thermal fuse on the blower housing is the usual no-heat cause, but a fuse that's blown twice means a shorted element or a packed vent, and we test for both. On the washers, F21 is a long-drain fault and usually a coin trap full of lint and change rather than a failed pump.

Maytag

Maytag runs on Whirlpool's platform, so the failures track together: thermal fuses and elements on the dryers, drain and spin faults on the washers. The older direct-drive top loaders are worth repairing — parts are available and the machines outlast most of what replaced them.

GE

GE dryers are straightforward machines and usually cheap to fix — heating elements, thermostats, belts, and drum bearings. Note that GE Profile Harmony washers and dryers are LG-built under the hood, so they diagnose like LG units, not like the rest of the GE line.

Kenmore

Kenmore is a badge, not a factory. Depending on the model prefix your machine was built by Whirlpool, LG, or Frigidaire, and the repair follows whoever built it. Have the full model number ready when you call and we'll know which platform we're walking into.

Frigidaire

Frigidaire front loaders come in for drain pumps, door boots, and bearing noise. On the dryers it's elements, thermostats, and belts. Parts are reasonably priced, so repair usually beats replacement well past the ten year mark.

Electrolux

Electrolux and Frigidaire share a platform, so parts and failure patterns overlap. We see drain pumps, door boot tears from overloading, and control issues. These are good machines and worth fixing.

Amana

Amana is Whirlpool-built and simple, which makes it cheap to repair. Belts, thermal fuses, lid switches, and drain pumps cover most of what we replace.

KitchenAid

KitchenAid laundry sets are Whirlpool machines and are getting old now, so parts availability matters more than the repair itself. We'll tell you honestly before ordering whether a part is still supplied for your model.

Bosch

Bosch compact 24-inch sets are common in Costa Mesa condos and closet installs. They need periodic filter and pump cleaning, and the condenser units need the heat exchanger kept clear. Different machine from a standard 27-inch set, and we work on them regularly.

Speed Queen

Speed Queen is built commercial-grade and lives in both homes and laundromats. Simple mechanically, which means repairs are fast and parts are available. If you own one, keep it.

Admiral

Admiral machines are older Whirlpool and Maytag builds. Most are past fifteen years now, so we'll give you a straight answer on whether the repair is worth the money before we start.

Commercial Laundry Equipment

Huebsch and Dexter have their own pages. We also service UniMac, Continental Girbau, Speed Queen, and Wascomat in laundromats, apartment laundry rooms, and hotels. Coin and card systems, drive belts and motors, heating, drain faults, and control boards. Downtime costs revenue, so we prioritize these calls.

Repair Pricing in Costa Mesa

• Diagnostic: $65, waived when you approve the repair
• Second unit: $30 for a second appliance on the same visit
• Warranty: 90 days on parts and labor

Completed repairs start at $200.

These are estimated prices, not a quote. The final price is confirmed after the technician inspects the machine.

The range covers the common repair on a freestanding unit. Control boards and drive motors are quoted separately, and board and motor parts vary by model. Stacked and closet-installed sets are quoted after inspection — pulling and restacking adds time to the job.

Under 10 years old, a machine is almost always worth repairing. Past that, we'll tell you straight whether the repair or a new machine is the better use of your money.

See typical times and estimated prices by problem →

Same-Day Service in Costa Mesa

Call before mid-afternoon and there's usually a slot the same day in Costa Mesa. If a washer is actively leaking, shut the water off at the two valves behind the machine and call — that stops the damage while we're on the way.

Our trucks carry the common failure parts for the major brands, which is why most calls are one visit. If a board or motor has to be ordered, we tell you the price and the timeline before anything is ordered.

Book a Repair in Costa Mesa

Call 949-979-4994 or book online. Tell us the brand, whether it's gas or electric, and the model number if you can reach it — it's on a sticker inside the door or behind the lid. If there's an error code on the display, that alone usually tells us what part to bring.

$65 diagnostic, waived with the repair. 90 days on parts and labor. Open seven days, 7 am to 9 pm.

Washer & Dryer Repair FAQ